Add ability to deselect selection. For example if too many faces are selected then ctrl works as inverse selection but no option to deselect all by block or line.

with clip Volume activated + delete mesh facet tool, it is not possible to delete only visible mesh Case CS0553942.

If you are using parametric modelling sometimes you run into situations where MS gives you: "One or more constraint has been removed." in the message center.First of all: It just shows as a small warning in the message center. That is not enough. ...

Parametric cells are great, shared cells are great using them in practice isn't so great.Parametric cells are stuck on the level, color, line weight and any other attribute associated with the "shared" cell within the file. So to save file space i...

This is the re submission of Case CS0546333. The Case CS0546333 reported the issue of incorrect Mesh Union caused by the start point of vector for mesh extrusion. Development Team considered it as an enhancement and I was asked to provide the idea...

Hello, Microstation allows you to create sectional views. It even allows you to create parallel sections by creating steps. However, it still doesn't allow you to create intersecting sections. And even less so to create a section following a Smart...

I see the enable toggle under feature properties but it would be much more powerful if you could tie it to a variable and let a true/false variable define it's state. This would allow users to turn many features on or off based on a single variable.

The MIN/MAX functions for a variable work fine within the same model where the variable is defined.However, when converting that model into a parametric cell and placing it into another project model, the MIN/MAX values are ignored, allowing both ...

I'd like an option so synchronize (live/dynamic) the viewpoint between multiple views. That way it would be possible to have two views side-by-side with different display style, or different level visibility. Then when rotating for example the lef...

Using the ground extraction process we can create an STM file without size limitation, but when we try to extract a Raster grid, we have a limitation of 50 Million of Pixels. Will be great to cancel that limitation. This limit has no need to be ha...